The home
of Opticlean

Camera Lens Images

Using Opti-Clean

Before you Start

 

Note:

Do not paint the polymer onto the lens. Allow it to flow freely from the brush. It is important to get a thick uniform coating to ensure satisfactory removal and cleaning.

 

[ The instructions below are only outline use. For the full instructions see the manual inside your purchased pack ]

 

Step One:

Step Two:

Step Three:
Step One Image Step Two Image Step three Image

1. Using a full brush, apply a circle of polymer to the lens about 1mm from the mount

2. Fill in the circle with a series of overlapping strips

3. Allow at least two minutes and up to five minutes for the polymer to fully cure

     

Step Four:

Step Five:

Step Six:
Step Four Image Step Five Image Step Six Image

4. Peel an adhesive tab from the backing sheet

5. Stick the tab to the edge of the film. Leave enough tab free to allow easy removal.

 

To ensure good contact use a fingernail or equivalent pointed object to push the tab against the edge of the film and lens mount.

 

Leave about half a minute for the adhesive to bond to the cured film

6. Lift edge of the film with a sharp tug on tab.

 

Peel the film carefully from the lens surface.